Architectural shingles
Metal roofing
Tile roofing
GAF
Owens Corning
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
What Does Roof Replacement Cost in Lomita, CA?
A full roof replacement in Lomita typically runs $12,500 to $21,000 for a standard single-story home, with architectural shingle tear-offs on the low end and coastal-spec systems with membrane tie-ins on the higher end. That coastal spec matters here more than in Torrance or anywhere inland. The marine layer and harbor salt air don’t just age a roof faster on one side – they change which materials actually last. Call (833) 589-7850 for a free estimate based on your specific roof, not a square-footage guess.
Salt Air on the Peninsula Slope Picks Your Roof Materials for You
We see the same pattern on roof after roof in Lomita, especially on the uphill streets climbing toward the Palos Verdes Peninsula. Marineland Avenue, Eshelman Avenue, parts of 90717 west of Narbonne – same story. The north-facing plane covered in fog until 10 a.m. shows algae streaking and moss in the shingle granules. The sun-baked front plane looks fine. Then you lift a few shingles and find the fasteners on the harbor-facing side have lost their zinc coating and are rusting through the shingle mat.
That’s the Lomita signature. Standard galvanized fasteners, which hold up fine twenty miles inland or even across PCH in West Carson, corrode here in eight to twelve years. The shingles themselves might have another decade in them, but the roof is already leaking at the drip edge and around pipe boots. A roofer who doesn’t work the peninsula slope won’t find it until the decking is soft and the job just doubled.
On a tear-off we did last year on a shallow-pitch rear plane up near Rolling Hills Estates, our crew pulled the shingles and found the decking soft in a diagonal band along the fog-shaded side. The drip edge had a white chalky bloom, and the original galvanized fasteners snapped instead of backing out. The sun-exposed front plane? Structurally sound. We replaced the rotten deck, ran ice and water shield through the valleys and every penetration, and reset the coastal-side flashing in stainless with hot-dip fasteners. The owner now has a tie-in between the original low-slope section and the added-on garage that drains winter rain instead of ponding it. That’s the difference between a roof spec’d for Lomita and a roof spec’d for anywhere.
Styles & brands we work with
Why Bedrock Roof Repair Is Lomita’s Roof Replacement Team
We’re a Roof Replacement contractor that starts with repair and only moves to replacement when the roof genuinely needs it. Alan Cofield built the company on that sequence, and our name is the public version of it. When a Lomita homeowner calls about a stain on the ceiling, we inspect first. Sometimes the answer is a $600 flashing repair and five more years of service. Sometimes it’s a full replacement. We’ll tell you which one your roof actually needs.
We work across all of 90717, from the flat streets near Lomita Boulevard up into the hills. That means we’ve handled the mid-century tract homes off Pennsylvania Avenue with their shallow pitches and added-on garages, and the steeper sections closer to the Peninsula where the north planes stay wet half the day. We source materials from seven manufacturers – GAF, CertainTeed, Owens Corning, IKO, Atlas, Tamko, and Boral – so the membrane we recommend for your low-slope rear section isn’t the same product we’d default to on a steep-pitch Torrance teardown. Brand-agnostic means the recommendation follows your roof’s drainage, exposure, and budget, not a supplier contract.
Roof Installation in Lomita
Roof installation in Lomita usually means one of three things: new construction, a full tear-off on an existing home, or adding a roof to a new addition or detached structure. The mid-century stock here shapes the work. Most Lomita homes built between 1950 and 1975 are stucco tract houses with shallow-pitch or low-slope roofs, plus detached garages and add-ons that are rarely tied in cleanly to the original roof. A proper installation on these homes means addressing drainage across those tie-ins, not just laying shingles over the old deck.
For new construction and additions in 90717, a roof installation typically runs $9 to $16 per square foot depending on pitch, decking condition, and whether we’re installing architectural shingles, low-slope membrane, or a combination. On an existing home, the price climbs with tear-off, decking replacement, and underlayment work. We never quote a new roof over questionable decking. If the fog has rotted the plywood, replacing it first is the only honest spec.
New Construction Roofing
We handle roof installation on new builds, ADUs, and garage conversions throughout Lomita. The key here is sequencing the roof with drainage before the rest of the building closes up. On shallow pitches, we spec self-adhered underlayment at the eaves and valleys, which protects against the wind-driven rain that comes in off the harbor during winter storms.
Roof Decking Replacement
When marine-layer moisture has been sitting against the underside of shingles for a decade, the decking under the north plane is often the first thing to go. We replace rotted plywood or OSB as part of a roof replacement rather than covering it and hoping. On the fog-shaded planes we see throughout Lomita, that’s a standard part of the job, not an upsell.
Roof Replacement Contractor in Lomita
A roof replacement contractor in Lomita has to understand that the two sides of your roof are living in different climates. The sun-baked south plane dries out by 9 a.m. and the shingles age from UV. The north plane sits in fog for hours and ages from moisture and organics. That’s why we inspect both planes separately and often specify different waterproofing details on the same roof. We’re not guessing – we’ve torn off enough Lomita roofs to know exactly where the rot starts.
Replacement costs for a typical 1,200 to 1,800 square-foot Lomita home run $12,500 to $21,000. Architectural shingle replacements on simple roofs sit at the lower end. Coastal-spec systems – stainless or hot-dip fasteners, ice and water shield at all penetrations and valleys, membrane on low-slope sections – push toward the higher end. The materials difference is usually $2,500 to $4,500 on a full roof. That’s not a markup; it’s the cost of not replacing the same fasteners in ten years.
Coastal-Spec Fastener and Flashing Systems
We default to stainless or hot-dip galvanized fasteners and flashings on any Lomita roof with exposure to harbor air. That’s most of them. The zinc on standard electro-galv fasteners gets eaten by salt before the shingles are halfway through their life. The upgrade costs a few hundred dollars in materials and saves the whole roof system.
Low-Slope and Flat Roofing
Many Lomita homes – and nearly all the detached garages – have low-slope or nearly flat rear sections. We install modified-bitumen and single-ply membranes on these, with sealed seams and proper positive drainage. If water ponds on the old roof for more than 48 hours after rain, the new membrane alone won’t fix it. We address the slope and taper before we lay the new roof.
Trusted Brands We Service in Lomita
We’re not tied to one manufacturer, so a Lomita roof isn’t forced into a system designed for a different climate. We install CertainTeed architectural shingles where the pitch and heat justify them, and we turn to Owens Corning and IKO products when the project calls for different profiles or warranties. For low-slope sections on the mid-century tract homes, we spec brands like GAF in Lomita and Boral with membrane systems that handle the fog-damp conditions without wicking moisture into the deck. Parts are sourced quickly for Lomita jobs, and we keep common flashing profiles stocked for the peninsula-side homes we serve.
See the difference
Before
After
Before
After
Before
AfterCommon Roof Replacement Problems We See in Lomita Homes
- Fog-shaded plane failure. The north and rear roof planes on uphill Lomita homes stay wet hours longer than the front, and the shingles, decking, and underlayment all age faster there. We routinely replace only half the deck on a tear-off – the half that’s been living in the marine layer.
- Salt-corroded fasteners and flashing. The harbor air carries salt that chews through standard galvanized fasteners and drip edge. By the time a Lomita roof leaks, the shingles often still look passable from the street. The failure is underneath.
- Ponding at garage and addition tie-ins. The 1950s-70s stucco tract houses throughout 90717 almost always have a flat or low-slope tie-in where an addition or detached garage meets the original roof. Most were flashed with substandard material and poor drainage from the start. We fix these with proper crickets, membranes, and stainless flashings.
- Algae and moss on damp planes. The daily wet-dry cycle the peninsula fog creates is perfect for organic growth on shingles. It’s ugly but more importantly, the trapped moisture shortens shingle life. We don’t just clean it – during replacement we address the underlying moisture exposure.
Pricing for Roof Replacement in Lomita, CA
Here’s what we see across the 90717 zip code, based on real quotes and completed jobs:
- Architectural shingle tear-off, simple 1,200-1,500 sq ft roof: $12,500 – $16,000
- Coastal-spec replacement, including stainless fasteners and ice-and-water shield at critical points: $15,000 – $21,000
- Low-slope or flat roof section with membrane, including drain correction: $11 – $14 per square foot
- Roof decking replacement: $2.50 – $4.00 per square foot of decking replaced, depending on how much fog rot we find
What moves the number most: decking condition, the number of low-slope sections and tie-ins, and whether you choose the inland-spec hardware or the coastal-spec hardware. The inland-spec bid often looks $3,000 to $4,000 cheaper. Then the fasteners start failing in year ten and you’re re-roofing twenty years ahead of schedule. We show both options on every bid and explain what each one costs over time. Call (833) 589-7850 and we’ll walk your actual roof, not a spreadsheet.
We Also Serve Cities Near Lomita
If you’re in Lomita, we’re already in your neighborhood. We also cover the surrounding South Bay communities: Torrance, Rolling Hills Estates, West Carson, and Manhattan Beach. Each has its own microclimate and building stock, and we spec to what the roof actually faces. Roof Replacement work across this area means adapting to everything from coastal salt to inland heat.
Serving Lomita, CA — Our Local Coverage Area
We’re based in the Lomita area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Roof Replacement in Lomita
The coastal-spec version costs $2,500 to $4,500 more because it uses stainless or hot-dip galvanized fasteners, coastal-rated flashing, and additional ice-and-water shield at penetrations and valleys. These materials resist the salt-laden harbor air that destroys standard galvanized hardware in eight to twelve years. The cheaper inland spec looks identical from the street and costs less up front, but the fasteners fail while the shingles still have life left, forcing a premature re-roof. Call (833) 589-7850 and we’ll show you both specs with the real lifespan math.
The marine layer that rolls up the peninsula slope every night keeps north-facing and fog-shaded planes damp for hours longer than the sun-exposed planes on the same house. That trapped moisture feeds algae, shortens shingle life, and rots decking years before the south plane shows any wear. We see it on nearly every tear-off in 90717 – one plane sound, the other soft and failing. The fix is specifying underlayment and waterproofing differently on the damp side, not treating both planes the same.
A re-roof on these Lomita homes usually involves tearing off the old shingles, replacing any fog-rotted decking on the north and rear planes, installing proper underlayment for shallow pitch, and addressing the tie-ins where additions and detached garages meet the original roof. Those tie-ins are almost always the source of ponding and leaks. We also correct drainage on low-slope sections before laying the new membrane. The job is not a simple shingle swap – it’s a drainage and waterproofing correction on a 60-year-old structure.
Line up the fasteners, flashing material, underlayment spec, and decking replacement terms side by side. If one bid uses standard electro-galv fasteners and another specifies stainless or hot-dip, that’s a $3,000 to $4,000 difference with a decade of lifespan attached. Check whether the bid includes new drip edge in a corrosion-resistant finish, and whether the decking replacement is quoted per-square-foot if rot is found. We provide written line-item bids so you can compare exactly what you’re paying for. Call (833) 589-7850 for a bid that shows every material and its spec.
The marine layer itself doesn’t change the shingle’s wind rating, but it does affect how shingles perform over time. Constant moisture on fog-shaded planes softens the asphalt matrix and can lead to granule loss and curling, which reduces the roof’s real-world wind resistance far below the manufacturer’s rating. The same shingle that holds 110 mph on a dry, sun-exposed plane in Torrance may fail at 70 mph on a permanently damp Lomita slope. We spec shingles and underlayment with that real-world condition in mind.
Written by Alan Cofield, Owner at Bedrock Roof Repair, serving Lomita and the South Bay.